Do you know what a laser leveler is? This is a device that uses laser as the reference plane, adopts the original receiving and transmitting system, and controls the leveling head in real time to achieve high-precision and fast leveling of concrete. The use of laser levelers provides a lot of convenience for engineering construction. So how should we maintain the laser leveler after normal use? In the following article, we will give you a detailed introduction. Thank you for your reading and support.
1. The Operation Method Of The Laser Leveler Is Introduced In Detail
① The operator checks the machine equipment before starting work, sets up the transmitter with the operator, and installs the handheld receiver; adjusts the scraper of the floor machine in a static state, and there must be no error between the two points; operates the concrete leveler, observes whether the machine is working properly, checks whether the laser receiver is in a horizontal position, and supervises whether the material feeder is timely in scraping and filling; at the end of the construction on the day, clean the machine after the laser leveler cools down, checks whether the functions of the machine are normal, and checks the power of the transmitter.
② The operator assists the operator in installing and debugging the machine, sets up the transmitter with the main operator, and installs the handheld receiver. Check whether the transmitter is placed safely; measure the height of the concrete after preliminary paving (the range is controlled within 2mm≥, ≤10MM); measure the height of the concrete after the laser leveling machine is leveled (the range shall not be lower than -2MM and not higher than 3MM). Focus: concrete edge and manually scraped concrete surface; after the construction is completed on the same day, clean the machine after the machine cools down and check the power of the handheld receiver.
③ When the 2 laser levelers are not in operation, the pavers will perform preliminary leveling of the concrete together with the pavers; when following the machine, they must obey the command of the main operator and scrape and fill the machine scraper position (the concrete material must not be lower than the scraper edge and must not be higher than 35MM from the scraper edge).
④ 2-4 pavers must obey the command of the operator; perform preliminary leveling of the concrete.
2. Laser Leveling Machine Manufacturers Tell How To Perform Maintenance
① The LCD surface on the laser leveling machine body also needs to be cleaned. You can use organic resin or lens-specific cleaning cloth to wipe the dirt. If there is too much dirt, you can use lens cleaning fluid to remove it.
② There will be a lot of dust and mud on the laser leveling machine after construction. First, wipe the dust off the laser leveling machine, and wipe the dirt and oil stains with thin paper or cotton cloth.
③ If the laser signal is lost during the construction of the laser leveling machine, the machine needs to be restarted, and the interval time needs to be more than ten seconds.
④ If there are too many stains, you can soak a soft cloth in water diluted with a neutral detergent, wring it out and wash it. The laser leveling machine manufacturer reminds everyone not to use volatile oil, thinner, gasoline and other chemicals for cleaning and wiping. The use of advanced construction equipment, concrete laser leveling machine, can not only shorten the construction period, but also ensure the construction quality to a great extent. This high-grade floor can guarantee normal use for more than 20 years, which can greatly reduce the cost of use and maintenance.
Through the introduction of the article, I believe everyone has learned about how to operate the laser leveling machine. If you have other aspects that you need to know or are interested in our products, please continue to pay attention to our official website. More exciting information is expected to be read and supported by you later.
