Phone

+86-19026181533

Read this article, replace the damaged parts of the laser leveling machine no longer detours

Dec 19, 2024 Leave a message

-2

 

As long as it is mechanical equipment, in the process of long-term use, there will inevitably be different degrees of parts wear or damage problems, which is naturally no exception for laser levelling machines. In order to ensure the normal use of the laser leveling machine and avoid burying safety hazards for subsequent operations, it is necessary for relevant personnel to master the correct replacement method of the main parts. In order to standardize the operation, the following professionals from the company to teach you several common wearing parts of the scientific replacement.

➤ Connecting rod and connecting rod cover replacement skills

The connecting rod of the horizontal diesel engine is divided by 45 degrees, and the section should be downward to change the stress of the connecting rod bolt. The connecting rod cover of the laser levelling machine is paired with the connecting rod, and the matching mark should be on the same side when assembling to ensure that the roundness and cylindricity of the connecting rod bearing meet the specified requirements.

➤ Main bearing cover, bushing, bushing replacement skills

The main bearing cover of the laser leveller and the bearing seat of the body are processed by pairing boring, which should be matched according to the pairing mark, and shall not be exchanged or changed in the assembly direction at will, so as not to destroy the coaxial degree and dimensional accuracy of the main bearing seat hole. The bearing bush or bushing with oil holes should be aligned with the corresponding oil passage holes on the bearing seat and bushing holes to ensure that the oil line is smooth.

➤ Cylinder gasket replacement skills

If there is an oil hole, align it with the corresponding oil passage hole on the laser leveling machine body and the cylinder head, so as not to cause friction caused by the valve mechanism on the cylinder head due to oil cut-off. There is no oil passage hole and the positive and negative shapes are the same, and the material of the cylinder head is determined: for the aluminum alloy cylinder head, the rolling side of the cylinder head should face the cylinder body; For cast iron cylinder heads, the flange side of the cylinder head should face the cylinder head.

➤ Piston and piston ring replacement skills

The piston marked with an upward arrow on the top shall be installed in the direction specified by the mark; If there is no mark, the vortex pit at the top of the piston or the small notch next to the pit should be directed towards the injector side to ensure uniform gas mixing. When assembling the piston ring for the laser levelling machine, the top of the "UP", "up" and other marks should face up; The top of the unmarked twist ring, the inner circle groove or chamfer should face down; The chrome-plated ring (shell shining) should be installed in a piston ring groove, and the ring openings should be staggered by 120 to 180 degrees to ensure the sealing effect.